Need help with mod chip!
Posted: Wed Sep 13, 2006 1:09 pm
I just installed a mod chip on my xbox (Xenium Gold 24K), and I followed the directions from different sites and I believe that I installed it correctly. The thing is that it doesn't work!
The reason that I think I installed it correctly is that the chip has four LED (Light Emitting Diodes) and they all should light when the gold pins are in the correct spot. I'm good there. Then when the chip is active one of the LEDs are suppose to go out; good there as well. So after I did that I reasembled the xbox and hooked it up and turned it on. I can see there is power to the console but nothing apears on the screen. The strange thing is when I turn it on it seems like it turns on, then off, then on, then off, and after the third time it stays on (screen still blank) and the green light around the eject button flashes from green to red, green to red, so on and so fourth.
Another thing I had a question about is that the dock where I connect the chip to the motherboard, there are 2 x 8 open holes to place the pins from the chip, but on the chip there are only 2 x 6 pins. Savvy? So it is like there are too many holes and three possibilities to place the chip. I thought it over and even if I try putting the chip in a different spot then it would only be in the way of the ribbon cable that is required to run the xbox. I am an IC (Internal Communications Electrician) with the USN and I am knowledgable with most electrical jargon. I am willing to trouble shoot this but I don't know where to go to get the info. If anyone can suggest something different (by way of personal experience) or any other means (by way of URL link) I would greatly appreciate it.
The reason that I think I installed it correctly is that the chip has four LED (Light Emitting Diodes) and they all should light when the gold pins are in the correct spot. I'm good there. Then when the chip is active one of the LEDs are suppose to go out; good there as well. So after I did that I reasembled the xbox and hooked it up and turned it on. I can see there is power to the console but nothing apears on the screen. The strange thing is when I turn it on it seems like it turns on, then off, then on, then off, and after the third time it stays on (screen still blank) and the green light around the eject button flashes from green to red, green to red, so on and so fourth.
Another thing I had a question about is that the dock where I connect the chip to the motherboard, there are 2 x 8 open holes to place the pins from the chip, but on the chip there are only 2 x 6 pins. Savvy? So it is like there are too many holes and three possibilities to place the chip. I thought it over and even if I try putting the chip in a different spot then it would only be in the way of the ribbon cable that is required to run the xbox. I am an IC (Internal Communications Electrician) with the USN and I am knowledgable with most electrical jargon. I am willing to trouble shoot this but I don't know where to go to get the info. If anyone can suggest something different (by way of personal experience) or any other means (by way of URL link) I would greatly appreciate it.