Please note that new user registrations disabled at this time.

Trap detection and/or stealth

This forum is to be used for all discussions pertaining to BioWare's Baldur's Gate and Baldur's Gate: Tales of the Sword Coast expansion pack.
Post Reply
User avatar
feodore
Posts: 1
Joined: Thu May 21, 2009 1:04 am
Contact:

Trap detection and/or stealth

Post by feodore »

Greetings folks. I'm in the middle of my first BG1 run-through (TotSC installed, no mods other than convenience tweaks (ammo/gem/potion stacking)). I have played through BG2 before although I never did get anywhere near finishing the game.

So here's a question ... or a series of (hopefully) related questions for you folks. How do you folks handle trap detection? Do you get your thief into trap detection modes in dungeons only? Do you send him/her ahead or does the entire party creep forward (painfully) slowly? Preferred formations for that scenario?

I vaguely remember being able to cast find traps (cleric spell) on my thief in BG2. That coupled with the stealth mode translated to safe scouting/trap detection. The find trap spell doesn't seem to have a target (self cast only) in BG1.
User avatar
galraen
Posts: 3727
Joined: Sat Nov 25, 2006 3:03 am
Location: Kernow (Cornwall), UK
Contact:

Post by galraen »

I've never bothered with the nerfed Find Traps spell, nerfed because it should (IMO) be Find & Remove Traps!

Sadly because the clerical spell is effectively useless one almost has to have a thief in BG games.

In BG I started out only checking for traps in dungeons, but found that to be a bad idea eventually. There are outdoor locations where cautious exploration is advisable.

I always have an advanced scout where the game permits though, checking not just for traps but for potential enemies, but doesn't everybody?
[QUOTE=Darth Gavinius;1096098]Distrbution of games, is becoming a little like Democracy (all about money and control) - in the end choice is an illusion and you have to choose your lesser evil.

And everything is hidden in the fine print.[/QUOTE]
Post Reply