DSII ActII-Ch8 problem

SamuraiX · Post by **SamuraiX** » Fri Aug 04, 2006 6:42 am

Hello, i have a little problem in Act II, chapter 8 (The Siege of Snowbrook Haven). I have to kill a dragon with the balista, but i can't seem to find the dragon. I found the balista but there is no dragon around it. I also went o every posibble path avaible but it's either a dead end or a locked door. Pls help me find the dragon. Also a chet would be usefull that "jumps" me after the dragon fight.
THX

swcarter · Post by **swcarter** » Fri Aug 04, 2006 2:16 pm

Have you patched your game? I know that a lot of people have had problems with the dragon, but I don't remember if they ever found a solution. Try searching the forum for "talon."

SWC

tom the terribl · Post by **tom the terribl** » Fri Aug 04, 2006 8:21 pm

The Dragion

Check your journel. Besure you have the quest. The game has a movie scene as you approach it. Just have your character ready to advance to the bilista and ready to position it. Just have fun.

First time after speaking with the capitan she says "kill all enemies up there". Be sure you kill all enemies before going back to talk with the captain. After clicking to answer she should say "they're approaching the Eastern wall. You should get the quest to kill the drageon. Just go do it.

SamuraiX · Post by **SamuraiX** » Sat Aug 05, 2006 1:51 am

I instaled the patch, but when i enter tha game it says version 2.0, not 2.2. And when i aproach the ballista there is no cut scene, and obviously no dragon. I have the quest in tha log.

Debbo · Post by **Debbo** » Sat Aug 05, 2006 4:06 am

Hello!
I had the SAME problem
go here
http://www.gamebanshee.com/forums/dunge ... 71800.html
download the file dragonfix.zip and put the file inside in the "resources" folder
This way u won't fight the dragon but u'll be able to go on with ur adventure ^^

SamuraiX · Post by **SamuraiX** » Sat Aug 05, 2006 12:23 pm

Thx, but unfortunatelly i installed the addon (broken world) this morning and it doesn't recognize my old character. I tried the "convert character" option and it couldn't find any character. So i'll just have to start over again