A huge bug with nwtoolset....

Fly Boy · Post by **Fly Boy** » Sun Jul 07, 2002 10:00 am

Allright, this may not be directly related to scripting but it has to do with creating a module.

I start up nwtoolset and start making a module, then an area.

I make it to the point where i am about to see my area in the window (unless i uncheck the one box) and i click finish. THen a window comes up saying:

Access violation at adress BF7A338 in module 'KERNEL32.DLL' Read of Address FFFFFFFF

When i say OK, the box appears again. THere are other very simmilar messages that occur in the same spot like 08A00008 instead of FFFFFFFF or different letters than BF7A338.

I can't view my areas, so i really cant use the program. Plz HELP!!

Ned Flanders · Post by **Ned Flanders** » Tue Jul 09, 2002 7:36 am

Try searching in the bioware forums. They have an extensive number of fourms, one devoted to technical troubleshooting for the aurora toolset.

babylon5uk · Post by **babylon5uk** » Wed Jul 17, 2002 12:07 am

Solution

I had the same problem, In my case it was because i had just updated to the detonater graphics drivers.
I then had much the same error codes appear.

I found out eventually that i needed to install the higghest level drivers for the original card first, then install the detonater drivers.
This updated the kernal32.dll among many other grahics links.

Fly Boy · Post by **Fly Boy** » Mon Jul 22, 2002 7:45 am

Wow, haven't checked this forum in a while. But yeah, that's what i did and it worked.