I'm not sure if anyone is still here but if so I require some help.
I'm up to the 3rd room in the Fu syndicate with the spinning blades that I assume are meant to be moving up and down the room, but they're not. So I shot out the the control panels to the back of the room to stop the blades and the guy says move on but the door doesn't open. So I enter the 'noclip' command but when exiting the console my game freezes up.
Any help would be appreciated.
Fu Syndicate - 3rd room
-
billybob721
- Posts: 1
- Joined: Thu Jan 10, 2013 10:01 pm
- Contact:
The entire place is one of the most glitchy in the game - BUT it usually only starts glitching out after saving and reloading once. So your best way around the problem is to load to a savegame that takes you to befóre you load that map. Like Chinatown. Re-enter the Fu Syndicate, play through it and try to avoid reloading your game as long as possible. The furthest room I recall having problems with was the room with all the electrics - but then again not always. The blades room glitched out much more often.
If you can get past the first three or so rooms without reloading (you're of course free to save, just in case) I think you should be in the clear. All the same, wait as long as you can.
If you can get past the first three or so rooms without reloading (you're of course free to save, just in case) I think you should be in the clear. All the same, wait as long as you can.
[INDENT]'..tolerance when fog rolls in clouds unfold your selfless wings feathers that float from arabesque pillows I sold to be consumed by the snow white cold if only the plaster could hold withstand the flam[url="http://bit.ly/foT0XQ"]e[/url] then this fountain torch would know no shame and be outstripped only by the sun that burns with the glory and honor of your..'[/INDENT]